QuoteJury › Cost guide › Furnace ignitor or flame sensor replacement › California

How much does furnace ignitor or flame sensor replacement cost in California?

Updated September 2026 · California price index 1.14 for HVAC work (national = 1.00)

In California, an HVAC company typically charges $110 to $430 to replace a furnace hot-surface ignitor or flame sensor, with most jobs landing near $210. That is about 14% above the national average of $95–$380, based on what HVAC technicians earn in California.

Low end
$110
Most jobs
$210
High end
$430
Got a quote for this in California? Check if it's fair — free

AI-powered second opinion using these same California figures. No account, no card. Need someone to do the work? Verified pros in California took the Fair Price Pledge.

What a California quote means

Quote for this jobWhat it means
Under $66Suspiciously low — ask what is excluded, and check licensing and insurance
$66 – $473Fair price — inside the typical range (up to 10% over the top is still normal)
$473 – $753Running high — get the quote itemized, and get a second one
Over $753Ripoff territory — more than 1.75× the high end of the typical range

Same rules the QuoteJury checker uses on every quote.

What you're paying for

What is usually included: Diagnosis, the part ($10–$60 for a flame sensor or ignitor), installation and a combustion check, usually within an hour.

What moves the price:

Both parts are under $50; the bill is the diagnostic fee plus a short labor block, so after-hours/emergency heat calls and OEM-only ignitors are what push it up.

Furnace ignitor or flame sensor replacement cost across California

Typical range by metro and rural area, from BLS wage data for HVAC technicians in each area.

AreaTypical rangeMost jobs
Bakersfield-Delano, CA$100 – $390$185
Chico, CA$95 – $380$180
El Centro, CA$105 – $420$200
Fresno, CA$95 – $380$180
Hanford-Corcoran, CA$95 – $380$180
Los Angeles-Long Beach-Anaheim, CA$110 – $430$210
Merced, CA$95 – $380$180
Modesto, CA$100 – $390$185
Napa, CA$115 – $470$220
Oxnard-Thousand Oaks-Ventura, CA$105 – $410$195
Redding, CA$95 – $380$180
Riverside-San Bernardino-Ontario, CA$95 – $390$185
Sacramento-Roseville-Folsom, CA$105 – $420$195
Salinas, CA$105 – $410$195
San Diego-Chula Vista-Carlsbad, CA$110 – $440$210
San Francisco-Oakland-Fremont, CA$120 – $480$230
San Jose-Sunnyvale-Santa Clara, CA$130 – $510$240
San Luis Obispo-Paso Robles, CA$105 – $430$200
Santa Cruz-Watsonville, CA$110 – $450$210
Santa Maria-Santa Barbara, CA$110 – $440$210
Santa Rosa-Petaluma, CA$115 – $450$220
Stockton-Lodi, CA$105 – $430$200
Vallejo, CA$105 – $420$200
Visalia, CA$95 – $380$180
Yuba City, CA$95 – $380$180
Eastern Sierra-Mother Lode Region of California nonmetropolitan area$95 – $390$185
North Coast Region of California nonmetropolitan area$100 – $400$190
North Valley-Northern Mountains Region of California nonmetropolitan area$95 – $380$180

Frequently asked

Is $210 a fair price for furnace ignitor or flame sensor replacement in California?

Yes. $210 is right around what most homeowners in California pay. Anything from $66 to $473 is inside the normal range for an HVAC company; above $473 it is worth getting a second quote.

Why do quotes for the same job vary so much?

Diagnostic fee versus repair cost; on this job the visit is most of the bill. Flame sensors can often be cleaned rather than replaced. Company overhead matters too: a large company with trucks, dispatchers and a warranty department charges more than a one-person shop, and both can be honest prices.

When should I get a second quote?

Any time a quote lands above $473, or when the contractor cannot break it into parts, labor and fees. Ask for the itemized version, ask what would change the price, and confirm licensing and insurance. You can also paste the quote into the free QuoteJury checker for an instant second opinion.

Other HVAC jobs in California

Furnace ignitor or flame sensor replacement in other states

Sources

About these numbers. Ranges are typical market rates for a licensed, insured contractor, blended from published U.S. cost guides and adjusted with U.S. Bureau of Labor Statistics wage data (OEWS, May 2025) for each state and metro area. They are estimates, not a bid, appraisal or inspection. Real prices move with parts, access, permits and code requirements. The quote checker is AI-powered and labeled as such.