QuoteJuryQuoteJury › Cost guide › 200-amp electrical panel upgrade › Alabama
How much does 200-amp electrical panel upgrade cost in Alabama?
Updated September 2026 · Alabama price index 0.91 for electrical work (national = 1.00)
In Alabama, a licensed electrician typically charges $1,200 to $4,100 to replace or upgrade a main electrical panel to 200 amps, with most jobs landing near $1,850. That is about 9% below the national average of $1,300–$4,500, based on what electricians earn in Alabama.
AI-powered second opinion using these same Alabama figures. No account, no card. Need someone to do the work? Verified pros in Alabama took the Fair Price Pledge.
What a Alabama quote means
| Quote for this job | What it means |
|---|---|
| Under $720 | Suspiciously low — ask what is excluded, and check licensing and insurance |
| $720 – $4,510 | Fair price — inside the typical range (up to 10% over the top is still normal) |
| $4,510 – $7,175 | Running high — get the quote itemized, and get a second one |
| Over $7,175 | Ripoff territory — more than 1.75× the high end of the typical range |
Same rules the QuoteJury checker uses on every quote.
What you're paying for
What is usually included: A new 200-amp load center with main breaker, transfer of existing circuits, grounding and bonding brought up to code, permit and inspection, and 4–8 hours of licensed electrician labor.
What moves the price:
- Whether the meter base and service entrance cable must be upgraded too (often $500–$1,500 more)
- Relocating the panel instead of replacing it in place
- Utility disconnect scheduling and permit fees, which vary by county
- Extra work uncovered during the swap: double-tapped breakers, aluminum branch wiring, missing grounds
- Arc-fault or surge protection add-ons the inspector or homeowner requests
Whether the meter/service entrance must also be upgraded, panel relocation, utility disconnect and permit/inspection, and regional labor rates.
200-amp electrical panel upgrade cost across Alabama
Typical range by metro and rural area, from BLS wage data for electricians in each area.
| Area | Typical range | Most jobs |
|---|---|---|
| Anniston-Oxford, AL | $1,150 – $3,950 | $1,800 |
| Auburn-Opelika, AL | $1,100 – $3,850 | $1,750 |
| Birmingham, AL | $1,200 – $4,150 | $1,850 |
| Daphne-Fairhope-Foley, AL | $1,100 – $3,750 | $1,700 |
| Decatur, AL | $1,300 – $4,400 | $2,000 |
| Dothan, AL | $1,050 – $3,600 | $1,600 |
| Florence-Muscle Shoals, AL | $1,200 – $4,100 | $1,850 |
| Gadsden, AL | $1,000 – $3,450 | $1,550 |
| Huntsville, AL | $1,250 – $4,350 | $1,950 |
| Mobile, AL | $1,250 – $4,350 | $1,950 |
| Montgomery, AL | $1,100 – $3,850 | $1,750 |
| Tuscaloosa, AL | $1,250 – $4,250 | $1,900 |
| Northeast Alabama nonmetropolitan area | $1,050 – $3,700 | $1,650 |
| Northwest Alabama nonmetropolitan area | $1,050 – $3,550 | $1,600 |
| Southeast Alabama nonmetropolitan area | $1,100 – $3,750 | $1,650 |
| Southwest Alabama nonmetropolitan area | $1,300 – $4,500 | $2,050 |
Frequently asked
Is $1,850 a fair price for 200-amp electrical panel upgrade in Alabama?
Yes. $1,850 is right around what most homeowners in Alabama pay. Anything from $720 to $4,510 is inside the normal range for a licensed electrician; above $4,510 it is worth getting a second quote.
Why do quotes for the same job vary so much?
Whether the meter base and service entrance cable must be upgraded too (often $500–$1,500 more). Relocating the panel instead of replacing it in place. Company overhead matters too: a large company with trucks, dispatchers and a warranty department charges more than a one-person shop, and both can be honest prices.
When should I get a second quote?
Any time a quote lands above $4,510, or when the contractor cannot break it into parts, labor and fees. Ask for the itemized version, ask what would change the price, and confirm licensing and insurance. You can also paste the quote into the free QuoteJury checker for an instant second opinion.
Other electrical jobs in Alabama
- Circuit breaker replacement
- Outlet installation or replacement
- GFCI outlet installation
- Light switch or dimmer installation
- Ceiling fan installation
- New 240-volt dedicated circuit
- Level 2 EV charger installation
- Manual generator transfer switch installation
- Whole-home standby generator installation
- Electrician service call and hourly rate
- Hardwired smoke detector replacement
- Recessed lighting installation
- Light fixture replacement
200-amp electrical panel upgrade in other states
United States (national) · Alaska · Arizona · Arkansas · California · Colorado · Connecticut · Delaware · District of Columbia · Florida · Georgia · Hawaii · Idaho · Illinois · Indiana · Iowa · Kansas · Kentucky · Louisiana · Maine · Maryland · Massachusetts · Michigan · Minnesota · Mississippi · Missouri · Montana · Nebraska · Nevada · New Hampshire · New Jersey · New Mexico · New York · North Carolina · North Dakota · Ohio · Oklahoma · Oregon · Pennsylvania · Rhode Island · South Carolina · South Dakota · Tennessee · Texas · Utah · Vermont · Virginia · Washington · West Virginia · Wisconsin · Wyoming
Sources
- HomeGuide (2026): $1,300–$2,500 nationally
- Angi (2026): $1,300–$2,000 nationally
- Fixr (2025): $1,800–$4,500 nationally
- This Old House (2026): $1,300–$3,000 nationally
- HomeAdvisor (2026): $1,300–$2,000 nationally
- U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025 — median hourly wages by state and metro area
About these numbers. Ranges are typical market rates for a licensed, insured contractor, blended from published U.S. cost guides and adjusted with U.S. Bureau of Labor Statistics wage data (OEWS, May 2025) for each state and metro area. They are estimates, not a bid, appraisal or inspection. Real prices move with parts, access, permits and code requirements. The quote checker is AI-powered and labeled as such.