QuoteJuryQuoteJury › Cost guide › GFCI outlet installation › New Mexico
How much does GFCI outlet installation cost in New Mexico?
Updated September 2026 · New Mexico price index 0.94 for electrical work (national = 1.00)
In New Mexico, a licensed electrician typically charges $85 to $280 to install a GFCI outlet, with most jobs landing near $195. That is about 6% below the national average of $90–$300, based on what electricians earn in New Mexico.
AI-powered second opinion using these same New Mexico figures. No account, no card. Need someone to do the work? Verified pros in New Mexico took the Fair Price Pledge.
What a New Mexico quote means
| Quote for this job | What it means |
|---|---|
| Under $51 | Suspiciously low — ask what is excluded, and check licensing and insurance |
| $51 – $308 | Fair price — inside the typical range (up to 10% over the top is still normal) |
| $308 – $490 | Running high — get the quote itemized, and get a second one |
| Over $490 | Ripoff territory — more than 1.75× the high end of the typical range |
Same rules the QuoteJury checker uses on every quote.
What you're paying for
What is usually included: A GFCI receptacle ($15–$40 in parts), wiring it so downstream outlets are protected, testing, and about an hour of labor.
What moves the price:
- Whether the circuit already has a ground; ungrounded circuits need a GFCI with a 'no equipment ground' label
- Protecting several downstream outlets from one GFCI versus installing GFCIs at each location
- Kitchen and bathroom code requirements that may pull in additional work during a permit inspection
- Weather-resistant models and in-use covers for outdoor locations
Replacing an existing outlet vs. adding a new one, outdoor/weatherproof locations, and the minimum service fee dominating a 15-minute job.
GFCI outlet installation cost across New Mexico
Typical range by metro and rural area, from BLS wage data for electricians in each area.
| Area | Typical range | Most jobs |
|---|---|---|
| Albuquerque, NM | $85 – $290 | $200 |
| Farmington, NM | $85 – $280 | $195 |
| Las Cruces, NM | $80 – $260 | $185 |
| Santa Fe, NM | $85 – $280 | $195 |
| Eastern New Mexico nonmetropolitan area | $85 – $280 | $195 |
| Northern New Mexico nonmetropolitan area | $85 – $290 | $200 |
Frequently asked
Is $195 a fair price for GFCI outlet installation in New Mexico?
Yes. $195 is right around what most homeowners in New Mexico pay. Anything from $51 to $308 is inside the normal range for a licensed electrician; above $308 it is worth getting a second quote.
Why do quotes for the same job vary so much?
Whether the circuit already has a ground; ungrounded circuits need a GFCI with a 'no equipment ground' label. Protecting several downstream outlets from one GFCI versus installing GFCIs at each location. Company overhead matters too: a large company with trucks, dispatchers and a warranty department charges more than a one-person shop, and both can be honest prices.
When should I get a second quote?
Any time a quote lands above $308, or when the contractor cannot break it into parts, labor and fees. Ask for the itemized version, ask what would change the price, and confirm licensing and insurance. You can also paste the quote into the free QuoteJury checker for an instant second opinion.
Other electrical jobs in New Mexico
- 200-amp electrical panel upgrade
- Circuit breaker replacement
- Outlet installation or replacement
- Light switch or dimmer installation
- Ceiling fan installation
- New 240-volt dedicated circuit
- Level 2 EV charger installation
- Manual generator transfer switch installation
- Whole-home standby generator installation
- Electrician service call and hourly rate
- Hardwired smoke detector replacement
- Recessed lighting installation
- Light fixture replacement
GFCI outlet installation in other states
United States (national) · Alabama · Alaska · Arizona · Arkansas · California · Colorado · Connecticut · Delaware · District of Columbia · Florida · Georgia · Hawaii · Idaho · Illinois · Indiana · Iowa · Kansas · Kentucky · Louisiana · Maine · Maryland · Massachusetts · Michigan · Minnesota · Mississippi · Missouri · Montana · Nebraska · Nevada · New Hampshire · New Jersey · New York · North Carolina · North Dakota · Ohio · Oklahoma · Oregon · Pennsylvania · Rhode Island · South Carolina · South Dakota · Tennessee · Texas · Utah · Vermont · Virginia · Washington · West Virginia · Wisconsin · Wyoming
Sources
- HomeGuide (2025): $90–$200 nationally
- Angi (2026): $130–$300 nationally
- HomeAdvisor (2026): $130–$300 nationally
- Bob Vila (2025): $130–$300 nationally
- U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025 — median hourly wages by state and metro area
About these numbers. Ranges are typical market rates for a licensed, insured contractor, blended from published U.S. cost guides and adjusted with U.S. Bureau of Labor Statistics wage data (OEWS, May 2025) for each state and metro area. They are estimates, not a bid, appraisal or inspection. Real prices move with parts, access, permits and code requirements. The quote checker is AI-powered and labeled as such.