QuoteJury › Cost guide › Circuit breaker replacement › New Mexico

How much does circuit breaker replacement cost in New Mexico?

Updated September 2026 · New Mexico price index 0.94 for electrical work (national = 1.00)

In New Mexico, a licensed electrician typically charges $45 to $280 to replace a single circuit breaker, with most jobs landing near $140. That is about 6% below the national average of $50–$300, based on what electricians earn in New Mexico.

Low end
$45
Most jobs
$140
High end
$280
Got a quote for this in New Mexico? Check if it's fair — free

AI-powered second opinion using these same New Mexico figures. No account, no card. Need someone to do the work? Verified pros in New Mexico took the Fair Price Pledge.

What a New Mexico quote means

Quote for this jobWhat it means
Under $27Suspiciously low — ask what is excluded, and check licensing and insurance
$27 – $308Fair price — inside the typical range (up to 10% over the top is still normal)
$308 – $490Running high — get the quote itemized, and get a second one
Over $490Ripoff territory — more than 1.75× the high end of the typical range

Same rules the QuoteJury checker uses on every quote.

What you're paying for

What is usually included: A standard 15–30 amp breaker, diagnosis of why it tripped or failed, the swap, and a service call of roughly an hour.

What moves the price:

Breaker type (standard vs. 2-pole, AFCI/GFCI, or main), availability of the panel brand's breaker, and the electrician's service-call minimum.

Circuit breaker replacement cost across New Mexico

Typical range by metro and rural area, from BLS wage data for electricians in each area.

AreaTypical rangeMost jobs
Albuquerque, NM$50 – $290$145
Farmington, NM$45 – $280$140
Las Cruces, NM$45 – $260$130
Santa Fe, NM$45 – $280$140
Eastern New Mexico nonmetropolitan area$45 – $280$140
Northern New Mexico nonmetropolitan area$50 – $290$145

Frequently asked

Is $140 a fair price for circuit breaker replacement in New Mexico?

Yes. $140 is right around what most homeowners in New Mexico pay. Anything from $27 to $308 is inside the normal range for a licensed electrician; above $308 it is worth getting a second quote.

Why do quotes for the same job vary so much?

Breaker type: standard, GFCI, AFCI or dual-function breakers cost $40–$120 each versus $10–$25 for a plain one. Obsolete panels (Federal Pacific, Zinsco, Pushmatic) where replacement breakers are scarce or unsafe. Company overhead matters too: a large company with trucks, dispatchers and a warranty department charges more than a one-person shop, and both can be honest prices.

When should I get a second quote?

Any time a quote lands above $308, or when the contractor cannot break it into parts, labor and fees. Ask for the itemized version, ask what would change the price, and confirm licensing and insurance. You can also paste the quote into the free QuoteJury checker for an instant second opinion.

Other electrical jobs in New Mexico

Circuit breaker replacement in other states

Sources

About these numbers. Ranges are typical market rates for a licensed, insured contractor, blended from published U.S. cost guides and adjusted with U.S. Bureau of Labor Statistics wage data (OEWS, May 2025) for each state and metro area. They are estimates, not a bid, appraisal or inspection. Real prices move with parts, access, permits and code requirements. The quote checker is AI-powered and labeled as such.