QuoteJury › Cost guide › New 240-volt dedicated circuit › Alaska

How much does new 240-volt dedicated circuit cost in Alaska?

Updated September 2026 · Alaska price index 1.28 for electrical work (national = 1.00)

In Alaska, a licensed electrician typically charges $320 to $1,300 to run a new dedicated 240V circuit for a dryer, range or EV charger, with most jobs landing near $780. That is about 28% above the national average of $250–$1,000, based on what electricians earn in Alaska.

Low end
$320
Most jobs
$780
High end
$1,300
Got a quote for this in Alaska? Check if it's fair — free

AI-powered second opinion using these same Alaska figures. No account, no card. Need someone to do the work? Verified pros in Alaska took the Fair Price Pledge.

What a Alaska quote means

Quote for this jobWhat it means
Under $192Suspiciously low — ask what is excluded, and check licensing and insurance
$192 – $1,430Fair price — inside the typical range (up to 10% over the top is still normal)
$1,430 – $2,275Running high — get the quote itemized, and get a second one
Over $2,275Ripoff territory — more than 1.75× the high end of the typical range

Same rules the QuoteJury checker uses on every quote.

What you're paying for

What is usually included: A double-pole breaker, appropriately sized cable for the run, a receptacle or hardwired termination, permit where required, and 2–4 hours of labor.

What moves the price:

Distance from the panel, amperage/wire gauge (30A dryer vs. 50A range or EV), fishing through finished walls, and whether the panel has space.

New 240-volt dedicated circuit cost across Alaska

Typical range by metro and rural area, from BLS wage data for electricians in each area.

AreaTypical rangeMost jobs
Anchorage, AK$300 – $1,200$740
Fairbanks-College, AK$340 – $1,350$830
Alaska nonmetropolitan area$330 – $1,300$790

Frequently asked

Is $780 a fair price for new 240-volt dedicated circuit in Alaska?

Yes. $780 is right around what most homeowners in Alaska pay. Anything from $192 to $1,430 is inside the normal range for a licensed electrician; above $1,430 it is worth getting a second quote.

Why do quotes for the same job vary so much?

Distance from the panel and whether the cable can run through an unfinished basement or must be fished through walls. Wire gauge: 50-amp circuits need heavier, pricier copper than 30-amp. Company overhead matters too: a large company with trucks, dispatchers and a warranty department charges more than a one-person shop, and both can be honest prices.

When should I get a second quote?

Any time a quote lands above $1,430, or when the contractor cannot break it into parts, labor and fees. Ask for the itemized version, ask what would change the price, and confirm licensing and insurance. You can also paste the quote into the free QuoteJury checker for an instant second opinion.

Other electrical jobs in Alaska

New 240-volt dedicated circuit in other states

Sources

About these numbers. Ranges are typical market rates for a licensed, insured contractor, blended from published U.S. cost guides and adjusted with U.S. Bureau of Labor Statistics wage data (OEWS, May 2025) for each state and metro area. They are estimates, not a bid, appraisal or inspection. Real prices move with parts, access, permits and code requirements. The quote checker is AI-powered and labeled as such.