QuoteJuryQuoteJury › Cost guide › New 240-volt dedicated circuit › New Hampshire
How much does new 240-volt dedicated circuit cost in New Hampshire?
Updated September 2026 · New Hampshire price index 1.02 for electrical work (national = 1.00)
In New Hampshire, a licensed electrician typically charges $260 to $1,000 to run a new dedicated 240V circuit for a dryer, range or EV charger, with most jobs landing near $620. That is about 2% above the national average of $250–$1,000, based on what electricians earn in New Hampshire.
AI-powered second opinion using these same New Hampshire figures. No account, no card. Need someone to do the work? Verified pros in New Hampshire took the Fair Price Pledge.
What a New Hampshire quote means
| Quote for this job | What it means |
|---|---|
| Under $156 | Suspiciously low — ask what is excluded, and check licensing and insurance |
| $156 – $1,100 | Fair price — inside the typical range (up to 10% over the top is still normal) |
| $1,100 – $1,750 | Running high — get the quote itemized, and get a second one |
| Over $1,750 | Ripoff territory — more than 1.75× the high end of the typical range |
Same rules the QuoteJury checker uses on every quote.
What you're paying for
What is usually included: A double-pole breaker, appropriately sized cable for the run, a receptacle or hardwired termination, permit where required, and 2–4 hours of labor.
What moves the price:
- Distance from the panel and whether the cable can run through an unfinished basement or must be fished through walls
- Wire gauge: 50-amp circuits need heavier, pricier copper than 30-amp
- Available panel capacity; a full panel can turn this into a subpanel or panel-upgrade job
- Permit and inspection requirements, which vary by city
Distance from the panel, amperage/wire gauge (30A dryer vs. 50A range or EV), fishing through finished walls, and whether the panel has space.
New 240-volt dedicated circuit cost across New Hampshire
Typical range by metro and rural area, from BLS wage data for electricians in each area.
| Area | Typical range | Most jobs |
|---|---|---|
| Manchester-Nashua, NH | $260 – $1,050 | $630 |
| Central New Hampshire nonmetropolitan area | $240 – $970 | $590 |
| Northern New Hampshire nonmetropolitan area | $250 – $990 | $600 |
| Southwestern New Hampshire nonmetropolitan area | $240 – $960 | $580 |
Frequently asked
Is $620 a fair price for new 240-volt dedicated circuit in New Hampshire?
Yes. $620 is right around what most homeowners in New Hampshire pay. Anything from $156 to $1,100 is inside the normal range for a licensed electrician; above $1,100 it is worth getting a second quote.
Why do quotes for the same job vary so much?
Distance from the panel and whether the cable can run through an unfinished basement or must be fished through walls. Wire gauge: 50-amp circuits need heavier, pricier copper than 30-amp. Company overhead matters too: a large company with trucks, dispatchers and a warranty department charges more than a one-person shop, and both can be honest prices.
When should I get a second quote?
Any time a quote lands above $1,100, or when the contractor cannot break it into parts, labor and fees. Ask for the itemized version, ask what would change the price, and confirm licensing and insurance. You can also paste the quote into the free QuoteJury checker for an instant second opinion.
Other electrical jobs in New Hampshire
- 200-amp electrical panel upgrade
- Circuit breaker replacement
- Outlet installation or replacement
- GFCI outlet installation
- Light switch or dimmer installation
- Ceiling fan installation
- Level 2 EV charger installation
- Manual generator transfer switch installation
- Whole-home standby generator installation
- Electrician service call and hourly rate
- Hardwired smoke detector replacement
- Recessed lighting installation
- Light fixture replacement
New 240-volt dedicated circuit in other states
United States (national) · Alabama · Alaska · Arizona · Arkansas · California · Colorado · Connecticut · Delaware · District of Columbia · Florida · Georgia · Hawaii · Idaho · Illinois · Indiana · Iowa · Kansas · Kentucky · Louisiana · Maine · Maryland · Massachusetts · Michigan · Minnesota · Mississippi · Missouri · Montana · Nebraska · Nevada · New Jersey · New Mexico · New York · North Carolina · North Dakota · Ohio · Oklahoma · Oregon · Pennsylvania · Rhode Island · South Carolina · South Dakota · Tennessee · Texas · Utah · Vermont · Virginia · Washington · West Virginia · Wisconsin · Wyoming
Sources
- HomeGuide (2025): $250–$900 nationally
- HomeGuide (2026): $250–$800 nationally
- HomeAdvisor (2026): $570–$1,000 nationally
- U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025 — median hourly wages by state and metro area
About these numbers. Ranges are typical market rates for a licensed, insured contractor, blended from published U.S. cost guides and adjusted with U.S. Bureau of Labor Statistics wage data (OEWS, May 2025) for each state and metro area. They are estimates, not a bid, appraisal or inspection. Real prices move with parts, access, permits and code requirements. The quote checker is AI-powered and labeled as such.