QuoteJury › Cost guide › New 240-volt dedicated circuit › Tennessee

How much does new 240-volt dedicated circuit cost in Tennessee?

Updated September 2026 · Tennessee price index 0.96 for electrical work (national = 1.00)

In Tennessee, a licensed electrician typically charges $240 to $960 to run a new dedicated 240V circuit for a dryer, range or EV charger, with most jobs landing near $590. That is about 4% below the national average of $250–$1,000, based on what electricians earn in Tennessee.

Low end
$240
Most jobs
$590
High end
$960
Got a quote for this in Tennessee? Check if it's fair — free

AI-powered second opinion using these same Tennessee figures. No account, no card. Need someone to do the work? Verified pros in Tennessee took the Fair Price Pledge.

What a Tennessee quote means

Quote for this jobWhat it means
Under $144Suspiciously low — ask what is excluded, and check licensing and insurance
$144 – $1,056Fair price — inside the typical range (up to 10% over the top is still normal)
$1,056 – $1,680Running high — get the quote itemized, and get a second one
Over $1,680Ripoff territory — more than 1.75× the high end of the typical range

Same rules the QuoteJury checker uses on every quote.

What you're paying for

What is usually included: A double-pole breaker, appropriately sized cable for the run, a receptacle or hardwired termination, permit where required, and 2–4 hours of labor.

What moves the price:

Distance from the panel, amperage/wire gauge (30A dryer vs. 50A range or EV), fishing through finished walls, and whether the panel has space.

New 240-volt dedicated circuit cost across Tennessee

Typical range by metro and rural area, from BLS wage data for electricians in each area.

AreaTypical rangeMost jobs
Chattanooga, TN-GA$260 – $1,050$650
Clarksville, TN-KY$230 – $930$570
Cleveland, TN$230 – $920$560
Jackson, TN$240 – $950$580
Johnson City, TN$220 – $870$530
Kingsport-Bristol, TN-VA$240 – $950$580
Knoxville, TN$240 – $940$570
Memphis, TN-MS-AR$240 – $960$590
Morristown, TN$230 – $920$560
Nashville-Davidson--Murfreesboro--Franklin, TN$250 – $1,000$610
East Tennessee nonmetropolitan area$210 – $850$520
North Central Tennessee nonmetropolitan area$210 – $860$520
South Central Tennessee nonmetropolitan area$220 – $890$550
West Tennessee nonmetropolitan area$230 – $910$550

Frequently asked

Is $590 a fair price for new 240-volt dedicated circuit in Tennessee?

Yes. $590 is right around what most homeowners in Tennessee pay. Anything from $144 to $1,056 is inside the normal range for a licensed electrician; above $1,056 it is worth getting a second quote.

Why do quotes for the same job vary so much?

Distance from the panel and whether the cable can run through an unfinished basement or must be fished through walls. Wire gauge: 50-amp circuits need heavier, pricier copper than 30-amp. Company overhead matters too: a large company with trucks, dispatchers and a warranty department charges more than a one-person shop, and both can be honest prices.

When should I get a second quote?

Any time a quote lands above $1,056, or when the contractor cannot break it into parts, labor and fees. Ask for the itemized version, ask what would change the price, and confirm licensing and insurance. You can also paste the quote into the free QuoteJury checker for an instant second opinion.

Other electrical jobs in Tennessee

New 240-volt dedicated circuit in other states

Sources

About these numbers. Ranges are typical market rates for a licensed, insured contractor, blended from published U.S. cost guides and adjusted with U.S. Bureau of Labor Statistics wage data (OEWS, May 2025) for each state and metro area. They are estimates, not a bid, appraisal or inspection. Real prices move with parts, access, permits and code requirements. The quote checker is AI-powered and labeled as such.