QuoteJuryQuoteJury › Cost guide › Furnace or air handler blower motor replacement › Arkansas
How much does furnace or air handler blower motor replacement cost in Arkansas?
Updated September 2026 · Arkansas price index 0.85 for HVAC work (national = 1.00)
In Arkansas, an HVAC company typically charges $210 to $2,050 to replace a furnace or air handler blower motor, with most jobs landing near $500. That is about 15% below the national average of $250–$2,400, based on what HVAC technicians earn in Arkansas.
AI-powered second opinion using these same Arkansas figures. No account, no card. Need someone to do the work? Verified pros in Arkansas took the Fair Price Pledge.
What a Arkansas quote means
| Quote for this job | What it means |
|---|---|
| Under $126 | Suspiciously low — ask what is excluded, and check licensing and insurance |
| $126 – $2,255 | Fair price — inside the typical range (up to 10% over the top is still normal) |
| $2,255 – $3,588 | Running high — get the quote itemized, and get a second one |
| Over $3,588 | Ripoff territory — more than 1.75× the high end of the typical range |
Same rules the QuoteJury checker uses on every quote.
What you're paying for
What is usually included: Diagnosis, the replacement motor (and capacitor or control module as needed), installation and testing, in 2–3 hours.
What moves the price:
- Motor type: a basic PSC motor costs a fraction of a variable-speed ECM motor, which can run $600–$1,500 in parts alone
- Parts warranty on the system, which can leave only labor to pay
- Access to the blower compartment
- Whether the control board also failed
PSC vs ECM/variable-speed motor is the biggest swing (ECM modules can be 2-3x), plus horsepower, OEM vs universal, and parts-warranty status.
Furnace or air handler blower motor replacement cost across Arkansas
Typical range by metro and rural area, from BLS wage data for HVAC technicians in each area.
| Area | Typical range | Most jobs |
|---|---|---|
| Fayetteville-Springdale-Rogers, AR | $230 – $2,200 | $540 |
| Fort Smith, AR-OK | $210 – $2,000 | $490 |
| Hot Springs, AR | $200 – $1,900 | $470 |
| Jonesboro, AR | $210 – $2,000 | $490 |
| Little Rock-North Little Rock-Conway, AR | $210 – $2,050 | $510 |
| East Arkansas nonmetropolitan area | $200 – $1,950 | $470 |
| North Arkansas nonmetropolitan area | $200 – $1,900 | $470 |
| South Arkansas nonmetropolitan area | $210 – $2,000 | $490 |
| West Arkansas nonmetropolitan area | $200 – $1,950 | $480 |
Frequently asked
Is $500 a fair price for furnace or air handler blower motor replacement in Arkansas?
Yes. $500 is right around what most homeowners in Arkansas pay. Anything from $126 to $2,255 is inside the normal range for an HVAC company; above $2,255 it is worth getting a second quote.
Why do quotes for the same job vary so much?
Motor type: a basic PSC motor costs a fraction of a variable-speed ECM motor, which can run $600–$1,500 in parts alone. Parts warranty on the system, which can leave only labor to pay. Company overhead matters too: a large company with trucks, dispatchers and a warranty department charges more than a one-person shop, and both can be honest prices.
When should I get a second quote?
Any time a quote lands above $2,255, or when the contractor cannot break it into parts, labor and fees. Ask for the itemized version, ask what would change the price, and confirm licensing and insurance. You can also paste the quote into the free QuoteJury checker for an instant second opinion.
Other HVAC jobs in Arkansas
- AC capacitor replacement
- AC contactor replacement
- Condenser fan motor replacement
- AC refrigerant recharge (R-410A)
- Evaporator coil replacement
- AC compressor replacement
- AC condenser (outdoor unit) replacement
- Full central AC system replacement (~3 tons)
- Gas furnace replacement
- Furnace ignitor or flame sensor replacement
- Smart thermostat installation
- Single-zone ductless mini-split installation
- HVAC service call and diagnostic fee
Furnace or air handler blower motor replacement in other states
United States (national) · Alabama · Alaska · Arizona · California · Colorado · Connecticut · Delaware · District of Columbia · Florida · Georgia · Hawaii · Idaho · Illinois · Indiana · Iowa · Kansas · Kentucky · Louisiana · Maine · Maryland · Massachusetts · Michigan · Minnesota · Mississippi · Missouri · Montana · Nebraska · Nevada · New Hampshire · New Jersey · New Mexico · New York · North Carolina · North Dakota · Ohio · Oklahoma · Oregon · Pennsylvania · Rhode Island · South Carolina · South Dakota · Tennessee · Texas · Utah · Vermont · Virginia · Washington · West Virginia · Wisconsin · Wyoming
Sources
- Angi (2026): $350–$2,400 nationally
- Bob Vila (2022): $250–$900 nationally
- HomeGuide (2025): $300–$900 nationally
- Fixr (2026): $300–$2,000 nationally
- U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025 — median hourly wages by state and metro area
About these numbers. Ranges are typical market rates for a licensed, insured contractor, blended from published U.S. cost guides and adjusted with U.S. Bureau of Labor Statistics wage data (OEWS, May 2025) for each state and metro area. They are estimates, not a bid, appraisal or inspection. Real prices move with parts, access, permits and code requirements. The quote checker is AI-powered and labeled as such.